Parker Hannifin Dynaserv G2 - Manual (Page 41)

4-6
Basic Settings for Operating the Motor
4
4.3 Installing the PC Utility on the PC
4.3.1 Procedure
Installation under Windows 95/98/98SE/Me/NT4.0/2000
The G2 PC utility (hereinafter referred to as the “PC utility”) runs on Windows 95, 98, 98SE, Me,
WindowsNT4.0 and 2000. It can be installed via “Add/Remove Programs” under the “Control Panel” in
Windows. If an older version of the PC utility is present, delete it first and then install the new version.
Display the “Properties of Adding/Removing Programs” dialog box and click “Set Up (1).” Then proceed
according to the instructions displayed on the screen. The PC utility setup program starts up.
Proceed with the setup according to the instructions on the screen. A dialog box for determining the directory in
which to install the PC utility appears (see Figure 4.3.1).
Figure 4.3.1 “Choose Destination Location” dialog box
Click “Browse” to display the “Select Directory” dialog box and select the desired drive and directory. Click
“Next” to display “Select Program Folder” (see Figure 4.3.2).