Parker Hannifin Dynaserv G2 - Manual (Page 174)

338 Zero signal status
Unit: None
Displays the zero signal status.
339 Sensor group signal status
Unit: None
Displays the sensor group signal status. Each bit in binary notation corresponds as follows:
bit0: (Reserved)
bit1: (Reserved)
bit2: (Reserved)
bit3: (Reserved)
bit4: ORG Origin neighboring signal
bit5: OTU + direction hardware over-travel signal
bit6: OTD - direction hardware over-travel signal
bit7: (Reserved)
340 Excessive position deviation status
Unit: None
Displays the excessive position deviation status.
341 Excessive velocity status
Unit: None
Displays the excessive velocity status.
342 Braking OFF
Unit: None
Indicates that the brake signal is OFF.
343 Position control integral main switch status
Unit: None
Displays the position control integral main switch status (0: OFF-disable, 1: ON-enable).
345 Error code (main)
Unit: None
Displays the error code (main code).
346 Error code (sub)
Unit: None
Displays the error code (subcode).