LOREX Technology NETWORK READY H.264 HIGH PERFORMANCE DIGITAL VIDEO SURVEILLANCE RECORDER LH300 Series - Manual (Page 50)

36
Using the Main Menu
8/16-channel
To configure the alarm settings:
1. From the Main Menu, click . The
Alarm menu opens.
2. Click and edit the following:
• Video Loss Alarm: Click under each
camera and select either O to enable
the VLoss alarm, or
X to disable it. If
enabled, the system will sound an
alarm whenever one of the connected
channels incurs a loss of video.
• Motion Enable: Click under each
camera and select O to enable motion
detection or select
X to disable it. If
enabled, the camera can record in
specific recording parameters when it
detects motion.
NOTE: With Motion Detection enabled,
the text, "Motion" appears on-screen
(full-screen and quad split-screen)
whenever a motion event is triggered.
• Buzzer: Select O to enable the system
to beep when an alarm is triggered or
motion is detected; select
X to disable
it.
• Key Buzzer: Select O to enable the
system beep when you click the mouse,
press the buttons on the remote/front
panel. Select
X to disable the beep.
• Alarm Input & Output: Click to open the
Alarm Input & Output menu.
• Alarm-In Type: Select OFF/ NO
(normally open) / NC (normally closed)
to select alarm type.
• Alarm-In Setup: Click to open the
Alarm-In Setup menu. Click to assign
channels to up to four alarms.
• Alarm-Out Setup: Click to open the
Alarm-Out Setup menu. Click to assign
an Event notification (Motion, VLoss,
Alarm) to an Alarm-Out notification
(Buzzer, Full-Screen, Label, Alarm Out
1).
• VLoss Response Time: Select the time
(in seconds) for the system to record
prior to a triggered event: 0, 3, 5, 10, 30,
60, 120, 180, or Infinite
Figure 13.1 Alarm menu (8/16-channel)
Figure 13.2 Alarm Input & Output menu
Figure 13.3 Alarm-In Setup menu (8/16-channel only )
Figure 13.4 Alarm-Out Setup menu