From the main menu, click . the record menu opens, Click format hdd, Figure 12.8 storage calculator – LOREX Technology NETWORK READY H.264 HIGH PERFORMANCE DIGITAL VIDEO SURVEILLANCE RECORDER LH300 Series User Manual

Page 48: Figure 12.9 storage calculator, Figure 13.0 alarm menu (4-channel), From the main menu, click . the alarm menu opens, Click and edit the following, Format hdd, Storage calculator, Alarm

Using the Main Menu

Format HDD

If you replace the pre-installed hard drive, the
new drive

must

be formatted in order to

function properly with the system.

To format the hard disk:

1. From the Main Menu, click

. The

Record menu opens.

2. Click Format HDD.

3. Click Yes to format the hard disk or click

No to cancel.

Please allow a few moments for formatting to
take place and the system to reset.

Storage Calculator

A storage calculator shows the approximate
maximum continuous recording time available
on the hard drive based on your settings. Use
the storage calculator to help maximize your
hard drive space.

NOTE:

The estimation from the Storage

Calculator is based

only

on Continuous

Recording, not motion or alarm recording.

Alarm

4-channel

Configure alarm and motion detection
settings.

To configure the alarm settings:

1. From the Main Menu, click

. The

Alarm menu opens.

2. Click and edit the following:

• Video Loss Alarm: Click under each

camera and select either O to enable
the VLoss alarm, or

to disable it. If

enabled, the system will sound an
alarm whenever one of the connected
channels incurs a loss of video.

• Motion Enable: Click under each

camera and select O to enable motion
detection or select

to disable it. If

enabled, the camera can record in
specific recording parameters when it
detects motion.

NOTE:

With Motion Detection enabled, the

text, "Motion" appears on-screen
(full-screen and quad split-screen)
whenever a motion event is triggered.

• Buzzer: Select O to enable the system

to beep when an alarm is triggered or
motion is detected; select

to disable

it.

• Key Buzzer: Select O to enable the

system beep when you click the mouse,
press the buttons on the remote/front
panel. Select

to disable the beep.

ATTENTION

: Formatting the HDD erases

all data

on the hard disk.

This step cannot

be undone

Figure 12.8 Storage calculator

Figure 12.9 Storage calculator

Figure 13.0 Alarm menu (4-channel)