LOREX Technology NETWORK READY H.264 HIGH PERFORMANCE DIGITAL VIDEO SURVEILLANCE RECORDER LH300 Series - Manual (Page 25)

11
Starting the System
STARTING THE SYSTEM
To power the system ON:
• Connect the power cable to the DC 12V port on the rear panel of the system
At startup, the system performs a basic system check and runs an initial loading sequence. After
a few moments, the system loads a live display view (
Live Mode ).
NOTE: Make sure all cameras and cables are properly connected prior to powering on the
system.
Onscreen Display
4-channel
1. System Status Bar: Displays mode, password type, recording mode, language, and status of
devices (HDD and USB).
2. Display: Full-screen single channel and Quad split-screen available in Live Viewing and
Playback modes; if cameras are disconnected, channels display a blue screen with the text,
"VLOSS."
Figure 4.0 Live viewing with on-screen display (4-channel model)
2
6
1
5
4
3