Sharp AR-M355N - Manual (Page 371)

KEY OPERATOR PROGRAMS
8-8
Call timer at memory sending
When sending a fax by automatic transmission
(See "Storing transmission jobs (memory
transmission)" on page 2-8.), this setting lets you
select the amount of time that the machine waits
before breaking the connection when the other
machine does not respond to your machine's
calling tone. If the other machine does not respond
within this set time, your machine will automatically
break the connection. Time selections are 30
seconds, 45 seconds, and 60 seconds. This setting
is normally set to 45 seconds.
Date/own number print position setting
This setting lets you select the position (inside or
outside the original image) of the sender's name
and number that are printed at the top of each fax
page you send. Normally OUTSIDE THE
ORIGINAL IMAGE is selected. To have your name
and number printed inside the original image, select
INSIDE THE ORIGINAL IMAGE. For more detailed
information on the position of each setting, refer to
"Position of sender's information" on page 3-11.
Quick on line sending
When this setting is turned on, the machine will call
the other machine and start transmitting the
document as soon as the first page is scanned.
Transmission therefore takes place at the same
time as any further pages are being scanned.
Normally this setting is turned on.
If you turn the setting off, transmission will not
begin until all pages of the document have been
scanned. Note that this setting does not apply to
manual transmission. (See "Storing transmission
jobs (memory transmission)" on page 2-8.)
Recall in case of line busy
This program is used to set the number of recall
attempts and the interval between recall attempts
when a transmission is not successful due to the
line being busy or other reason.
Normally the machine is set to make 2 recall
attempts at intervals of 3 minutes.
The number of recall attempts can be set to any
number from 1 to 14, and the interval between
attempts can be set to any number of minutes from
1 to 15.
If you do not wish recalling to take place, select
[TURN OFF RECALL].
Recall in case of communication error
When sending a document, this setting is used to
select whether your machine will re-attempt the call if
the transmission fails due to a line error.
Normally the machine is set to make 1 recall
attempts at intervals of 1 minute.
The number of recall attempts can be set to only 1
time, and the interval between attempts can be set
to any number of minutes from 1 to 15. If you do not
wish recalling to take place, select [TURN OFF
RECALL].
NOTE
Even if this setting is turned on, your machine will not
re-attempt the call when a document is sent by
manual transmission.
NOTE
Even if this setting is turned on, your machine will not
re-attempt the call when a document is sent by
manual transmission.
Tiger2_08.fm 8 ページ ２００４年９月２０日 月曜日 午前９時５３分