Sharp AR-M355N - Manual (Page 299)

1-12
CONVENIENT DIALING METHODS
The fax function includes a convenient auto dial feature (one-touch dialing and group dialing). By programming
frequently dialed numbers, you can call and send documents to these locations by means of a simple dialing
operation (refer to page 2-4). There are two types of auto-dialing: one-touch dialing and group dialing. To program
auto-dial numbers, refer to pages 6-3, 6-6.
● One-touch dialing
Simply press a one-touch key and then press the [Start]
key to dial the programmed location. A name of up to 36
characters can be programmed for the location (a
maximum of 18 characters are displayed). When using F-
code transmission, a sub-address and passcode can also
be programmed (refer to page 4-2).
Touch the
[ADDRESS] key in
the initial screen to
display the left
screen.
● Group dialing
Multiple one-touch dial locations can be programmed into
a single one-touch key. This is convenient for successively
sending a document to multiple locations.
• Full fax numbers entered with the numeric keys can also
be stored in group keys.
Touch the
[ADDRESS] key in
the initial screen to
display the left
screen.
● Speed dialing
When a one-touch key or group key is stored in the
address book, the machine automatically assigns it a 3-
digit speed dial number.
The
key and 3-digit Speed Dial number can be used
to abbreviate the transmission procedure.
● Redialing
The machine keeps the last fax number dialed with the
numeric keys in memory. You can redial the last number
dialed by simply touching the [RESEND] key.
• If numeric keys were pressed during a phone
conversation, the [RESEND] key may not dial the correct
number.
• If the previous transmission was a broadcast
transmission in which one-touch keys were used, the
[RESEND] key cannot be used.
● On-hook dialing
This is a dialing function. This feature allows you to dial
without lifting an extension phone connected to the
machine. Touch the [SPEAKER] key, listen for the dial
tone through the speaker, and then dial.
• Faxes must be sent manually when using on-hook dialing.
• On-hook dialing is not possible using a one-touch key that
includes a sub-address and passcode, or a group dial key.
NOTES
● Programmed one-touch keys and group dial keys are stored on "index cards". A one-touch key or group key can
be easily accessed by touching the index key. (Refer to on page 1-5.)
● To prevent calling or sending a fax to a wrong number, look carefully at the touch panel and make sure you
program the correct number when programming an auto-dial number. After storing a number, you can also print
out the stored number (Refer to page 6-14) to make sure it was stored correctly.
FREQUENT USE ABCD EFGHI JKLMN OPQRS
CORPO.TPS
SHARP GROUP
SHARP CORPORATION
SHARP CORPORATION
0666211221
SHARP CORPORATION
FREQUENT USE ABCD EFGHI JKLMN OPQRST
CORPO.TPS
SHARP GROUP
SHARP GROUP
GROUP:025
SPEAKER
RESEND PEAKER
SWITCH
FAX
ADDRESS BOOK
ADDRESS REVIEW
RES SPEAKER
MODE SWITCH
FAX
ADDRES
ADDRESS
Tiger2_fax_sec.book 12 ページ ２００４年９月１６日 木曜日 午前８時５３分