Sharp AR-M355N - Manual (Page 254)

14
PROGRAMS FOR COPY MODE
This chapter explains the key operator programs that are used for copy mode.
Copy settings
"Copy settings" consists of the following programs:
● Initial status settings
● Exposure adjustment
● Rotation copy setting
● Add or change extra preset ratios
● 600dpi x 600dpi scanning mode for document
feeder
● Quick scan from document glass
● Initial margin shift setting
● Erase width adjustment
*1
● Card shot settings
*1
● Setting a maximum number of copies
● Disabling deletion of job programs
● Disabling of bypass-tray in duplex copy
● Disabling of auto paper selection
*1 Default settings selected with these programs apply
to all functions of the machine (not just the copy
function).
Initial status settings
The copy settings revert to the default settings when
the power switch is turned on, when the [CA] key is
pressed, or when the auto clear time elapses. This
program is used to change the default settings, or
return changed default settings to the initial factory
default settings.
Defaults for the following copy settings can be
changed:
Paper tray/Exposure tray/Copy ratio/2-sided copy/Out
put (auto, sort, staple sort, group, output tray)
Exposure adjustment
This program is used to adjust the exposure level when
"Auto" is used for the copy exposure.
The factory setting is "5". "1" indicates lighter density
and "9" indicates darker density on the touch panel.
Rotation copy setting
If this program is set, the image of originals will rotate
when the orientation of the originals does not match
that of the copy paper.
(Rotation copy will function only if the auto paper select
or auto image mode has been selected.)
Add or change extra preset ratios
When using inch sizes, there are normally four preset
enlargement ratios and four preset reduction ratios.
When using AB sizes, there are normally five preset
enlargement ratios and five preset reduction ratios.
This program allows you to add two more preset
enlargement ratios and two more preset reduction ratios.
This program also allows you to change a preset ratio.
600dpi x 600dpi scanning mode for document
feeder
Use this program to change the original scanning
resolution of the automatic document feeder from 600
x 300 dpi to 600 x 600 dpi.
If this mode is set, the copy quality for fine characters
and fine lines will be improved but the original scanning
speed will be slower.
Quick scan from document glass
Use this program to change the original scanning
resolution on the document glass from 600 x 600dpi to
600 x 300 dpi.
If you set this program, the first copy time will be shorter
but the copy image will become a little more coarse.
NOTE
If this program is used to change the default setting
for the duplex function to other than "one-sided"
"one-sided" and the automatic document feeder fails
or is disabled, the setting will revert to "one-sided"
"one-sided".
* DISABLING OF DOCUMENT FEEDER (page 11)
DISABLING OF DUPLEX (page 11)
NOTE
For copying from 5-1/2" x 8-1/2" or A5 size originals
onto 5-1/2" x 8-1/2"R or A5R paper, this program
must be set.
NOTE
Only an added preset ratio can be changed.
NOTE
If the original scanning speed is more important than
higher resolution, do not set this program.
NOTE
If the copy image quality is more important than first
copy time, do not set this program.
Keyop_Sec.book 14 ページ ２００４年９月１５日 水曜日 午後８時３８分