Sharp AR-M355N - Manual (Page 244)

4
USING THE KEY OPERATOR PROGRAMS
The procedure for configuring the key operator programs is explained below using the "Key operator code change"
program as an example. Follow the same steps to configure the programs that are explained beginning on page 7.
1 Press the [CUSTOM SETTINGS] key.
2 Touch the [KEY OPERATOR PROGRAMS]
key.
3 Use the numeric keys to enter the five-digit
key operator code.
Each time a number is
entered, the dashes (-)
in the display will change
to asterisks ( ). The
factory default setting for
the key operator code
number is 00000.
4 Touch the [KEY OPERATOR CODE
CHANGE] key .
If you wish to configure a
different program, select
the program in this step.
A setting screen for the
selected program will
appear. See the
explanation of the
program on page 7.
5 Use the numeric keys to enter the new
5-digit key operator code.
Use a number for the
key operator code that
has not been
programmed as an
account number for
auditing mode (a
number that has been
programmed as an account number cannot be
used). The entered number will be the new key
operator code. Be sure to remember this number.
6 Touch the [OK] key. You will return to the
screen of step 4.
This completes the
procedure for changing
the key operator code. If
you wish to configure
another program, touch
the key of the desired
program in the screen of
step 4.
7 Press the [CA] key to exit the program.
You will exit the key
operator programs and
return to the main
screen.
KEY OPERATOR PROGRAMS
SENDER CONTROL
FAX DATA
RECEIVE/FORWARD
KEY OPERATOR CODE
KEY OPERATOR
CODE CHANGE
NGS
PRINTER
SETTINGS
00000 -----
OK
Keyop_Sec.book 4 ページ ２００４年９月１５日 水曜日 午後８時３８分