Sharp AR-M355N - Manual (Page 142)

5-43
5
INTERRUPTING A COPY RUN
The copy of the original scanned in interrupt mode is output before the remainder of the interrupted copy job.
1 Touch the [INTERRUPT] key.
If interrupt copying is
possible during a copy
run, the [INTERRUPT]
key will appear. (If the
key does not appear,
interrupt copying is not
possible.)
When the [INTERRUPT]
key is touched in step 1,
the [INTERRUPT] key
will be replaced by the
[CANCEL] key as shown
in the illustration.
To cancel an interrupt
copy job while the interrupt original is being
scanned or while you are selecting copy settings,
touch the [CANCEL] key.
2 Place the original for the interrupt copy job
in the document feeder or on the
document glass (page 4-3).
3 Select the exposure mode, paper size,
number of copies, and any other copy
settings as needed, and then press the
[START] key.
4 The previous copy job automatically
resumes after the interrupt job finishes.
NOTES
● If you touch the [INTERRUPT] key when auditing
mode is enabled, the display will prompt you to
enter your account number. Enter your account
number with the numeric keys. The copies you
make will be added to the count of the entered
account number.
● If a copy is being printed when the [INTERRUPT]
key is pressed, interrupt mode will begin after the
copy is finished.
● If the document glass is used for an interrupt copy
job, two-sided copying, sort copying, and staple
sort copying cannot be selected. If any of these
functions are necessary, use the document
feeder.
AUTO
AUTO
AUTO 8x
ORIGINA
RIGINAL
EXPOSUR
8 x11
INTERRUPT
1/ 2
CANCEL
ORIGINAL 8 x11
0
AUTO
EXPOSURE
AUTO 8 x11 1/ 2
EXPOSURE
AUTO 8 x11 1/ 2
PAPER SELECT
100%
1/ 2