Symbol Technologies MC9000-G - Manual (Page 283)

Accessories 7-7
To insert the MMC:
1. Remove the two keypad screws and slide the keypad down and lift off (see Figure 7-1 on
page 7-5 ).
2. Lift the MMC retaining door.
3. Position the MMC, with the contacts down, into the MMC holder. The MMC corner notch
fits into the holder only one way. Snap the retaining door closed.
Figure 7-3. Inserting the MMC
Do not apply more than 4 in-lbs of torque when tightening the keypad screws.
4. Replace the keypad and re-attach using the two screws (see Figure 7-2 on page 7-6 ).
MMC
MMC Retaining Door