JVC CB100 - Manual (Page 97)

Chapter 4—Setup Adjustments
HJT Model 100 User's Guide 4-45
Figure 4.0-23 Quad Standard Decoder Module (with Line Doubler) VIC
4.12. Updating Software
The projector's software resides in F LASH M EMORY and is updated via the
projector's serial Port A. To perform an update, a disk containing the updated
Boot Software (boot.hex) and/or System Software (ssys.hex) and a PC with
W
INDOWS 3.1 (VT-100 Emulator) is required to perform update.
Boot Manager Software and System Software are separate products—each may
be updated independently but the System Software will depend on a specific
version of the Boot Manager.
NOTE: Refer to the any System Software release bulletin for Boot Manager
version dependencies.
To perform Software Upgrade:
1. Use a Null Modem cable to connect a PC to the projector’s Serial Port A.
2. Start W INDOWS 3.1.
3. Click on the Terminal Icon from the A CCESSORIES D IRECTORY .
4. From the T ERMINAL MENU , select S ETTINGS -T ERMINAL E MULATION and click
on DEC-VT-100(ANSI). Select OK.
5. Under S ETTINGS choose T ERMINAL P REFERENCES .
6. Under T ERMINAL P REFERENCES , select the appropriate preferences listed in
Table 4.0-9.