JVC CB100 - Manual (Page 79)

Chapter 4—Setup Adjustments
HJT Model 100 User's Guide 4-27
Figure 4.0-14 Three (3) Cursor Modes
Move Mode
M OVE MODE with the arrow pattern in
the center.
Use the up/down and right/left keys to
move the cursor to the area of the
screen that needs convergence.
When the cursor is in the area
desired, press M
ODE to change the
cursor to the S IZE mode below.
Size Mode
S IZE MODE with the arrows at the
edges.
Use the left/right and up/down
arrow keys to adjust the cursor to
the size needed.
Adjust Mode
The area to be adjusted is
enclosed in a rectangular border.
Areas outside the rectangle are
not affected. The area most
affected is the center of the
rectangle.
Do not try to make large
adjustments at the edges of the
rectangle.
Move the cursor so that the
center is over the area to be
corrected.