JVC CB100 - Manual (Page 56)

Chapter 4—Setup Adjustments
4-4 Hughes-JVC Technology Corporation
Adjustment Explaination
R, G or B
Adjustments
Adjustments can be performed on individual colors if the RGB letters
are in the window on the screen. Selecting one (1) color makes it
adjustable but all three (3) colors still remain on the screen (unless
hidden by the H
IDE key).
Pressing E SCAPE immediately removes RGB displays.
For any
Adjustment
Pressing M ODE speeds up the adjustment by a 4 to 1 ratio.
Press M ODE again to toggle back to the single digit adjustment rate.
End of any Timing
or Geometry
Adjustment
Press E NTER or E SCAPE to exit.
Convergence
Adjustments
Pressing E NTER while performing Convergence changes the
M OVE /S IZE mode to the A DJUST mode.
Performing
Convergence
Procedures
Press E SCAPE to exit the adjustment.
General Information
Verify that O NSCRN key is toggled to O N if the screen does not show
the window or menu correctly.
When performing ILA
®
S ENSITIVITY AND B IAS , B LACK L EVEL (G2),
S ENSITIVITY O FFSET , and U NIFORMITY (S HADING ), verify that the
S HUTTERS ON H IDE box under the S YSTEM -P REFERENCES menu is
checked. Checking this box activates the shutter mechanism to
hide the ILA
®
images and provides easier, more accurate settings
of these adjustments.
On single-axis adjustments such as P ICTURE S ETTINGS , G2,
T HRESHOLD , S ENSITIVITY , ILA
®
B IAS etc. up/down arrow keys are
shown on the screen—left/right arrow keys, though not shown, will
also accomplish the same adjustments.
After completing the timing, geometric, and convergence adjustments for one (1)
source, the adjustment data may be backed up by copying the channel to another
of the 99 channels and the source file to another of the 20 sources.
NOTE: When backing up a channel, ensure that the “copied to” channel is blank.
Channel paste is only allowed to “cut” empty channel. Source paste will overwrite
current source geometry, convergence and ILA
®
settings. All data will be deleted
on the “copied to” channel. Refer to the Backing up Settings function from Section
4.10 on page 4-38 for more detail.
This provides backup for a previously set up channel and a good starting point for
setting up other channels. Also ensure that the "copied to" channel uses the
same type of VIC as the "copied from" channel. If the projector uses only one (1)
VIC, this is not applicable.