JVC CB100 - Manual (Page 46)

Chapter 3—Operation
3-18 Hughes-JVC Technology Corporation
# MAIN MENU Description
# Sub-Menu Description
3. S OURCES Displays input sources, horizontal and vertical rates sync type/polarity,
interlaced or noninterlaced scanning. Contains a submenu for editing,
copying, cutting or pasting any source names like the channel list menu.
Indicates active source with a pointer. Highlights the sources that are
attached to the channel that is highlighted on the channel list.
4. T IMING Displays the timing menu and adjustments.
1 P HASE Horizontal and vertical adjustment for picture phase.
2 T/L B LANKING Adjustment for top/left blanking.
3 B/R B LANKING Adjustment for bottom/right blanking.
4 C LAMP T YPE Pick list for type of clamping preferred. Selections are BackPorch,
SyncTip, or TriLevel. Default is back porch.
5 VTR M ODE Toggle for VTR ON or OFF. Default is OFF.
5. G EOMETRY Displays the following raster adjustments:
1 S IZE Value adjustment for width and height (All = Coarse: R & B = Fine).
2 C ENTERING Value adjustment for red, green and blue, horizontal and vertical
centering.
3 K EYSTONE Value adjustment for left, right, top, and bottom keystone
correction.
4 P INCUSHION Value adjustment for left, right, top, and bottom pincushion
correction.
5 B OW Value adjustment for left, right, top, and bottom bow correction.
6 S KEW /R OTATE Value adjustment for the red, green and blue horizontal skew and
rotation.
7 L INEARITY Value adjustment for red, green, and blue, vertical and horizontal
linearity correction.
8 E DGE L INEARITY Value adjustment for horizontal and vertical edge linearity
correction.
9 R EG E NABLE Menu toggle to enable convergence (XY R EGISTRATION ). This box
should be un-checked only when doing Geometry procedures or
for specific maintenance by service personnel. The default is O
N .