JVC CB100 - Manual (Page 80)

Chapter 4—Setup Adjustments
4-28 Hughes-JVC Technology Corporation
To adjust XY Registration:
1. Access the G EOMETRY MENU .
2. Verify that the R EG E NABLE box is checked. This toggle is normally ON
and is toggled to OFFonly for maintenance.
3. Use the RGB TOGGLE and the H IDE KEY to hide Red and Blue.
4. If Green geometry is good, unhide Red and Blue.
O R if Green geometry is questionable, recheck it now.
a. Use the Standard Crosshatch test pattern to verify.
b. If geometry is not satisfactory, make touch-up corrections.
c. Green geometry must be correct before proceeding because Green is
used as a reference to converge Red and Blue.
d. If necessary, repeat any timing or geometry adjustments from Section 4.2
on page 4-9 and Section 4.3 on page 4-11
5. Access the T EST P ATTERN MENU and select RGB X-hatch. This test pattern is
a series of Red, Green, and Blue bars that form small rectangles on the
screen. The rectangles in Figure 4.0-15 show a Correctly Converged RGB
Pattern and Figure 4.0-16 illustrates Incorrectly Converged RGB Patterns
(two examples). If this is a black and white illustration, Red is shown as
white, Green as shaded, and Blue as black.
6. Access the C ONVERGENCE MENU and select R EGISTRATION . The convergence
screen will display one of the cursor modes shown in Figure 4.0-14.
7. Use S IZE MODE first. If the M OVE MODE displays, press M ODE to toggle to the
S IZE MODE . If the A DJUST MODE displays, press E NTER to toggle to the
M OVE /S IZE MODE then, if necessary, press M ODE to toggle to the S IZE MODE .
8. Use the S IZE MODE to increase the cursor size to a full screen cursor.
To view a full screen cursor:
a. Move the cursor to the center of the screen.
b. Toggle the M ODE KEY to the M OVE CURSOR .
c. Use the arrow keys to place the cursor at the center of the screen, then
toggle the M
ODE KEY to return to the S IZE MODE .
d. Continue to size the cursor to a full screen.
Figure 4.0-15 Correctly Converged RGB Pattern
Blue
Red
Green