JVC CB100 - Manual (Page 35)

Chapter 2—Installation
HJT Model 100 User's Guide 3-7
9 Grey Color Balance (Gamma).
To display an internal test pattern:
1. Select M ENU on remote.
2. Select S YSTEM from M AIN M ENU shown on screen.
3. Select T EST P ATTERN from S YSTEM Menu.
4. Select desired T EST P ATTERN to be displayed.
3.5. Displaying External Signals
The internal test pattern on the screen shows that the projector is working
properly. An external signal can now be displayed.
The HJT Model 100 Projector has four (4) factory-preset channels. The operator
can select one (1) of these preset channels to automatically display four (4) of the
standard signals currently used. These signals have been stored in Channel 1.
The operator can view the name and characteristics of these sources by selecting
M
ENU and then selecting C HANNEL .Table 3.0-3 shows the on-screen display of the
factory-preset channels menu.
Table 3.0-3 On-Screen Factory-Preset Channel Menu Display
CHANNELS CH 1 [INT]
# Name VIC Sources
1 Facto 1.1 VGA
XGA
SXGA
81.1kHz
2 . . . . . . . . .
3 . . . . . . . . .
4 . . . . . . . . .
Table 3.0-4 defines designations displayed in Table 3.0-4.
Table 3.0-4 Factory-Preset Channels Menu Display Definitions
Display Description
CH1 [INT] Indicates channel # selected from 0 to 99.
# Lists the channel numbers.
Name Name given to that channel # (using up to 5 characters i.e. F ACTO for Factory).
VIC Video input port the external signals must be connected to. Default is 1.1 with no
optional VICs used. With optional VICs this could be 2.1, 2.2 , 2.3 or 2.4.
Sources Type of signal that have been programmed into the respective channels.
In this case, Channel 1 contains four (4) signal sources types.