JVC CB100 - Manual (Page 78)

Chapter 4—Setup Adjustments
4-26 Hughes-JVC Technology Corporation
Figure 4.0-12 Full-Screen Cursor
Center at Upper Left (Point 1)
Figure 4.0-13 ¼ Screen Cursor
Center at Upper Left (Point 1)
Start with the full screen cursor
center at Point 1 and make
corrections.
Then move center of cursor down to
Point 2 and make corrections.
Continue placing center of cursor to
points numbered over entire screen
(top line of the current cursor should
be at the same point as the bottom
line of the previous cursor).
When as much as possible has been
done with the full screen cursor,
change to the ¼ screen cursor in
Figure 4.0-13 below.
Start converging with the ¼
screen cursor at the upper
left corner.
Then move the center of the
cursor through the points in
the sequence shown in the
same manner and adjust in
the same manner as the full
screen cursor.