JVC CB100 - Manual (Page 105)

HJT Model 100 User's Guide 6-1
6.0 System Specifications
NOTE: HJT Model 100 Projector specifications are subject to change without notice.
Image Quality
Brightness 1500 ANSI Lumens.
Contrast Ratio 200:1 Sequential. 150:1 ANSI.
RGB Bandwidth 120 Mhz (measured at -3 db point).
Aspect Ratio 4:3 - 16:9 (variable).
Uniformity 1.5:1 center to edge - ANSI points.
3:1 center to corner.
Graphics Resolution 2000 (H) x 1500 (V).
Video Resolution 1500 TV line (4:3).
Video Response Time • 16.7 ms.
Color Coordinates SMPTE 240M.
Input Compatibility
Horizontal Scan Frequency 30-135 kHz.
Vertical Scan Frequency 50-150 Hzs.
Blanking • 2.3 µs (H) • 500 µs (V).
Source Compatibility 2730 (H) x 2048 (V).
Parameter Storage 99 Channels/20 Sources.
Decoder (optional) Optional PAL/SECAM/NTSC (3.58/4.43) with line doubler.
Inputs
RGB Input Cards (VIC) 75 ohm BNC input for R,G,B,H,V.
Signal Level .5-1.2V p-p /Offset:
±
3VDC(0.7V Nominal).
Sync Level .3-4V p-p, Composite Sync(H), separate H&V, or Sync on
Green(G) / Offset:
±
3VDC.
Decoder Video Input Card
(Optional) 75 ohm BNC inputs for Composite and Y/C.
Video Level 1V p-p with Sync / Offset:
±
3 VDC.
S-Video Y Level 1V p-p with Sync / Offset:
±
3 VDC.
C Level 300mV p-p / Offset:
±
3 VDC.
Switching Time Between
Sources
• 2 Sec.
Control Ports
Terminal 2 full RS-232 inputs for ANSI Terminal, tethered remote, External
Video Switcher or Serial External Communications Protocol with
DATA spec up to 19.2k BAUD.
Tethered IR Remote Input connection for remote control or IR Repeater.
IR Remote Front and rear receivers.