JVC CB100 - Manual (Page 33)

Chapter 2—Installation
HJT Model 100 User's Guide 3-5
Table 3.0-1 Remote Control Key Functions
Key Function Usage
Power Press ON to turn power on, and OFF to turn power off. Press to turn power on or off.
Menu Toggles on/off M AIN M ENU display. Press once to display M AIN M ENU ,
second time to hide M AIN M ENU .
Escape Cancels last command and retreats one menu level,
cancels an input, exits adjustment
Press to back out of current menu.
Enter Implements commands, chooses an item exits an
adjustment, goes to next menu level
Press E NTER when selection is
highlighted or to exit an adjustment.
Cont Contrast. Change the amount of image intensity. Press C ONT + left/right arrows to set
level.
Bright Brightness. Adjust until black portions of a projected
image are black, but detail in color balanced areas
is not lost.
Press B RIGHT + left/right arrows to set
brightness level.
Arrows Used for increasing and decreasing control levels,
cursor movement, convergence and geometry
Phase Horizontal and vertical Phase adjustment of the input
image on the CRT raster.
Press P HASE + left/right arrow keys to
set H phase or up/down arrows to set
V phase.
Blank Blanking. Adjusts blanking levels at image edges.
Press once for T/L and again for B/R.
Access T/L (top/left) or B/R
(bottom/right) blanking from Timing.
Adjust with arrows.
Size Adjusts projected image height and width on screen. Press S IZE + arrows to set ht/width.
Center Adjusts image raster horizontally and vertically on
screen.
Use up/down and left/right arrows to
center.
Onscrn Toggles on/off the "on screen" information display. Toggles “on screen” display O N /O FF .
RGB Color selection to adjust or hide Toggle to desired color.
Hide Blanks CRTs for all colors or selected color. Toggles video or selected color on or
off.
Lin Horizontal and Vertical Linearity correction for improper
grid spacing on an image.
Press L IN + Left/Right or Up/Down
arrows to correct linearity distortion.
Edge Lin Edge Linearity. Horizontal and Vertical edge linearity
correction for improper grid spacing at image sides.
Press E DGE + Left/Right or Up/Down key
to correct edge linearity distortion.
Mode Provides menu to edit Channels or Sources lists. Press to edit C HANNELS or S OURCES .
XYReg Enters Registration (XY) convergence adjustment. Press XYR EG . See Section 4.6.
Numbers Selects the input signal channel and makes Menu
selections.
Press channel or menu number.
Thresh Enters Threshold convergence adjustment. Press T HRESH . See Section 4.8.2 .
Sens Enters Sensitivity convergence adjustment. Press S ENS . See Section 4.8.1 .
Pin Vertical and horizontal pincushion correction for
distortion at the sides or top and bottom of an image
Press P IN + arrows to correct vertical
and horizontal pincushion distortion.
Key Keystone. Horizontal and vertical keystone correction for
grid line distortion at the sides or top and bottom of
an image with respect to the center line
Press K EY + left/right or up/down keys to
correct horizontal or vertical
keystoning.
Bow Adjust picture bowing Press B OW -use arrows to correct.
Skew Corrects for slight yoke rotation. Press S KEW -use arrows to correct.
Lens Projection lens Zoom/Focus. Press L ENS . Up/down arrows to zoom.
Left/right arrows to focus.
Pattern Displays test pattern menu. Press P ATTERN . Select a test pattern.
Bulleted keys are available on both the Standard and Technician Remotes.