JVC CB100 - Manual (Page 48)

Chapter 3—Operation
3-20 Hughes-JVC Technology Corporation
# MAIN MENU Description
# Sub-Menu Description
7. S YSTEM Displays the System menu and its six submenus as shown below:
4 C OMM S ETUP Menu selection for type of device for port A/B and baud speed.
The defaults for Port A are ANSI Terminal and 9600 Baud.
The defaults for Port B are N
ONE and 9600 Baud.
If a Video Switcher is being used, it must be selected for either
Port A or B from the Comm. Setup menu. Select a speed of 9600
Baud for Port A or 19200 for Port B.
NOTE: Video Switchers and the Tethered Remote option should
be connected to Port B. This allows for Boot Manager to use an
ANSI Terminal on Port A to upgrade software without the need
for reconfiguring.
5 F ACTORY
A DJUSTMENTS
1 ILA
®
B IAS Red, green, and blue ILA
®
light valve
bias adjustment. Must be done
whenever light valve components are
replaced or ILA
®
Sensitivity is changed.
2 ILA
®
S ENSITIVITY
Value adjustment for light valve bias
frequency.
3 CRT F OCUS Value adjustment for R, G, or B CRT
focus.
4 H/V D YNAMIC
F OCUS
Value adjustment for horizontal and
vertical dynamic focus.
6 M AINT . U TILITIES Provides a submenu below for maintenance purposes:
1 S TATUS Displays projector parameters such as;
software revision, VIC types, channel
information, lamp hours, projector
(system controller) hours.
2 D ISPLAY S YSTEM
E RROR L OG
Display screen for system errors.
3 R ESET S YSTEM
E RROR L OG
Dialog to confirm reset.
4 E XPORT
C ONFIGURATION
Dialog for saving the projector’s setup
data to an external host for backup.
This backup data can be imported
whenever a System Controller board is
replaced.
5 I MPORT
C ONFIGURATION
Used with #4 E XPORT C ONFIGURATION
above.
6 R ESET L AMP
T IMER
Dialog to change timer value.