JVC CB100 - Manual (Page 50)

Chapter 3—Operation
3-22 Hughes-JVC Technology Corporation
3.13. PC or VT-100 Terminal Control
The projector can be controlled by a VT-100 terminal. If a VT-100 is not available,
a PC with W
INDOWS 3.1 or P RO C OMM for DOS can emulate a VT-100. Table 3.0-
10 on page 3-23 shows the equivalent commands for the terminal and both
remotes.
To control the projector by a PC or VT-100 Terminal:
1. From W INDOWS P ROGRAM M ANAGER , select T ERMINAL , then S ETTINGS .
2. Select T ERMINAL E MULATION from S ETTINGS MENU .
3. Select DEC VT-100(ANSI) (may already be selected).
4. Use a Null Modem cable to connect between the projector and the terminal.
5. Refer to Section 3.13.1Terminal Preferences and 3.13.2 Communications
Protocol for W INDOWS setup.
3.13.1. Terminal Preferences
Select S ETTINGS again from the menu bar. Select T ERMINAL
P REFERENCES . Set the modes as indicated in Table 3.0-8 below.
Table 3.0-8 Terminal Preferences
Modes Modes
Line Wrap Yes CR # # # # CR/LF
Local Echo No Inbound No
Sound Yes Outbound No
Columns Cursor
80 Yes Block Yes
132 No Underline No
Terminal Font Blink Yes
Courier 12 Translations NONE
Terminal Show IBM to ANSI No
Scroll Bars Yes Buffer Lines 100
Use Function Arrow and Control keys for Windows No