JVC CB100 - Manual (Page 38)

Chapter 2—Installation
3-10 Hughes-JVC Technology Corporation
3.6.4. Menu Selection Examples
Three (3) examples of selections made using numbered menus follow.
See Figure 3.0-3 on page 3-11 for a Menu Structure Diagram.
To select the test pattern for Linearity:
1. Press M ENU (and E SCAPE , if necessary) to display the M AIN M ENU .
2. Select the S YSTEM menu.
3. From the S YSTEM menu, select T EST P ATTERN .
4. From the T EST P ATTERN list, select X- HATCH .
5. The standard crosshatch test pattern appears on the screen.
To select Linearity for adjustment purposes:
(Continue from the above test pattern selection.)
1. Press M ENU and/or E SCAPE to display the M AIN M ENU .
2. Select the G EOMETRY menu.
3. From the G EOMETRY menu, select L INEARITY .
4. The Linearity adjustment window appears on the screen.
NOTE: It is also possible to move from side to side in the menu tree.
For example, when in the S YSTEM menu, #7, (above first example) to
go to #4, T IMING , (above second example) press the left arrow three
(3) times to move three (3) places to the left. To move back to the
S
YSTEM menu, press the right arrow three (3) times. During setup
adjustments this feature can save time when moving between Picture,
Timing, Geometry, and Convergence.
To select a Video Switcher:
1. Under M ENU S ETUP , Port A or Port B device, select V IDEO S WITCHER .
2. Select a baud speed of 9600 if the switcher is connected to Port A
OR a speed of 19200 if the switcher is connected to Port B.
NOTE: Switchers are recommended to be connected to Port B.
This allows for B OOT M ANAGER to be connected to Port A through the
ANSI terminal when software upgrades are needed without the need
for reconfiguring the ports.
3. Turn power off with the remote, or PC to shut the system down.
4. Restart the system to activate changes (cycle AC power off and back on).
Add a third digit to VIC channel assignment to show that a switcher is
being used (see Section 4.11 on page 4-39 about Video Input Cards).