JVC CB100 - Manual (Page 101)

Chapter 4—Setup Adjustments
HJT Model 100 User's Guide 4-49
c. A progress indicator shows the number of records received while the
upload is occurring. The system will display the following at the
completion of the upload:
d. The system has verified that the load module is correct and is ready to
update the Flash. Press E
NTER to perform the update (E SC now to
abort the update with no changes). Do not turn off the power during
the 15 to 30 seconds the Flash is updated (the machine will be un-
bootable, requiring installation of a new set of flash chips).
9. When the Boot software has been successfully updated, re-start the
projector by entering the REBOOT command , then press E NTER . The
projector will now restart with the updated System Software.
S-records processed: xxx
Upload Successful
Address Range: 0x00000000-0x0000xxxx
Bytes Loaded: xxxxx
* * * WARNING: FLASH WILL NOW BE UPDATED * * *
Press E NTER to continue, E SC to abort
Reprogramming Flash Sector 2 3 4 5 6 7 8 9
System software update successful
Command: __