Honeywell MS-9200UDLSE - Manual (Page 90)

Programming
90 MS-9200UDLS PN 52750:E1 01/27/09
Pressing 2 while viewing the Noun/Adjective Screen will cause the following
screen(s) to be displayed. Note that the keyboard down arrow key must be pressed
to see all the Noun screens. Press the number corresponding to the noun that is to
be used as a descriptor for the location of the control module currently being
programmed.
Pressing 3 or 4 while viewing the Noun/Adjective Screen will display screens
similar to the previous Adjective and Noun Screens. The new screens will list
Custom Adjectives and Nouns which have been programmed into the control panel
using the PS-Tools programming utility.
1=STANDARD ADJECTIVE
2=STANDARD NOUN
3=CUSTOM ADJECTIVE
4=CUSTOM NOUN
Noun/Adjective Screen
**********************
1=BASEMENT
2=BOILER RM
3=CLASSROOM
Noun Screen #1
**********************
1=CLOSET
2=CORRIDOR
3=ELECTRIC RM
Noun Screen #2
**********************
1=ELEVATOR
2=ENTRANCE
3=FLOOR
Noun Screen #3
**********************
1=GARAGE
2=HALLWAY
3=HVAC RM
Noun Screen #4
**********************
1=KITCHEN
2=LOBBY
3=OFFICE
Noun Screen #5
**********************
1=STAIRWAY
2=STOREROOM
3=WING
Noun Screen #7
**********************
1=PATIENT
2=RESTROOM
3=ROOM
Noun Screen #6
**********************
1=ZONE
Noun Screen #8