beautypg.com

Honeywell MS-9200UDLSE User Manual

Page 117

background image

Programming

MS-9200UDLS PN 52750:E1 01/27/09

117

Annunciator addressing is specific to the MS-9200UDLS control panel. The
following table describes the annunciator addresses and the corresponding
addressable devices that will be annunciated at each annunciator address.

The MS-9200UDLS must be programmed for the annunciators installed on the
system. Refer to "Annunciators" on page 115 for information on annunciator
programming. Make certain to program the annunciator addresses that have been
physically installed on the system.

Note: The 8 General System Status Points include the following:

ACS Annunciator Address

Annunciator Displays the Following Points

1

8 General System Status Points & Zones 1 - 56

2

Zones 57 - 99 & 4 NACs

3

SLC Loop, Module Addresses 1 - 64

4

not used

5

SLC Loop, Module Addresses 65 - 99

6

not used

7

not used

8

SLC Loop, Detector Addresses 1 - 64

9

not used

10

SLC Loop, Detector Addresses 65 - 99

11

not used

12

not used

13

not used

14

not used

15

not used

16

not used

17

not used

18

not used

19

not used

20

8 General System Status Points & Zones 1 - 56

21

Zones 57 - 99 & 4 NACs

22

SLC Loop, Module Addresses 1 - 64

23

not used

24

SLC Loop, Module Addresses 65 - 99

25

not used

26

not used

27

SLC Loop, Detector Addresses 1 - 64

28

not used

29

SLC Loop, Detector Addresses 65 - 99

30

not used

31

not used

32

not used

• General Alarm

• Alarm Silenced

• Battery Fault

• General Trouble

• System Off Normal

• NAC Fault

• General Supervisory

• AC Loss

This manual is related to the following products: