beautypg.com

11 clear program, Clear program 1=whole system 2=all points, Warning! system change proceed? 1=yes 2=no – Honeywell MS-9200UDLSE User Manual

Page 144

background image

Programming

144

MS-9200UDLS PN 52750:E1 01/27/09

3.6.11 Clear Program

Pressing 2 while viewing Programming Screen #4, will select the Clear Program
option. This will cause the LCD to display the following screen:

Pressing 1, for Whole System while viewing the Clear Program Screen #1, will clear all
general system programming options and all programmed addressable devices from the
nonvolatile memory of the FACP. This function is useful when the control panel is first
installed, prior to autoprogramming. Note that it is necessary to autoprogram after
using the Clear Whole System function.

Pressing 2, for ALL POINTS while viewing the Clear Program Screen #1, will clear all
programming related to the SLC loop and connected addressable devices.

Before executing any of the Clear commands listed above, the control panel will
provide a warning to the user by prompting with the following display:

Pressing 1 will cause the control panel to carry out the selected clear option. Pressing 2
will prevent programming from being cleared.

PROGRAMMING
1=PASSWORD CHANGE
2=CLEAR PROGRAM
3=PROGRAM CHECK

Programming Screen #4

CLEAR PROGRAM
1=WHOLE SYSTEM
2=ALL POINTS

Clear Program Screen #1

See Page

WARNING!
SYSTEM CHANGE
PROCEED?
1=YES 2=NO

This manual is related to the following products: