beautypg.com

5 programming and passwords – Honeywell MS-9200UDLSE User Manual

Page 62

background image

Programming

62

MS-9200UDLS PN 52750:E1 01/27/09

3.5 Programming and Passwords

There are two factory set programming passwords which will access the Programming
screens as indicated in the following examples. From either of the screens, access to
specific system and device features or programming may be obtained. All user
programming entries are stored in nonvolatile memory. The factory set passwords can
be changed by the user as described in "Password Change" on page 143. If an invalid
password is entered, the blinking cursor will return to the first password character
position. To exit Programming or Read Status mode at any time, press the ESC
(Escape) key repeatedly. Note that Programming mode must be exited using the ESC
key in order to store the program data entered during this mode. If the Reset key is
pressed or power is lost before exiting Programming mode, the data just entered will
not be saved.

To access user Programming mode, press the Enter or Mode key. The LCD will display
the following:

To enter the user Programming mode, press 2. The display will read as follows:

Entering the Master level password (default 00000) will cause the following screen to
appear:

If the Maintenance level password (default 11111) is entered, the following screen will
appear:

Note that in the two preceding screens, an arrow appears to inform the programmer that
additional options can be viewed by pressing the keypad down arrow key.

See Page

1=READ STATUS MODE
2=PROGRAMMING MODE
3=REMOTE DOWNLOAD

PROGRAMMING
ENTER PASSWORD
*****

PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP

PROGRAMMING
1=POINT PROGRAM
2=HISTORY
3=PROGRAM CHECK

This manual is related to the following products: