Honeywell MS-9200UDLSE - Manual (Page 66)

Programming
66 MS-9200UDLS PN 52750:E1 01/27/09
When the type has been selected, the following screen will be displayed:
The programmer can continue adding detectors by pressing the ESC key which will
return the display to the Add Detector Screen.
3.6.2.1.2 Delete Detector
Pressing 2 in the Detector Screen will display the Delete Detector Screen which
allows the programmer to delete a specific detector:
A flashing cursor will appear in the position of the first asterisk to the left. The
programmer keys in the three digit detector address, such as 005. When the last
digit is keyed-in, the following screen will be displayed:
The programmer can continue deleting detectors by pressing the ESC key which
will return the display to the Delete Detector Screen.
3.6.2.1.3 Edit Detector
The programmer can change a detectors existing or factory default programming by
pressing 3 in the Detector Screen. The following screen will be displayed:
A flashing cursor will appear in the position of the first asterisk to the left. The
programmer keys in the three digit detector address, such as 017.
When the last digit is keyed-in, if the selected address has not been added to
programming, a screen showing information about a device that is installed with a
lower address, closest to the selected address, will be displayed.
ADD DETECTOR
DETECTOR# 005
IS ADDED
DETECTOR
1=ADD
2=DELETE
3=EDIT
Detector Screen
DELETE DETECTOR
ENTER DETECTOR#
***
Delete Detector Screen
DELETE DETECTOR
DETECTOR# 005
IS DELETED
EDIT DETECTOR
ENTER POINT ADDRESS
***
Edit Detector Screen