Henny Penny OEA/OGA-323 - Manual (Page 64)

Model OFE/OFG-321,322,323,324
SECTION 5. TROUBLESHOOTING
5-1. TROUBLESHOOTING GUIDE
Problem Cause Correction
POWER switch ON but fryer
• Open circuit • Plug fryer in
completely inoperative
• Check breaker or fuse at supply
box
Shortening will not • Open high limit • Reset high limit per
heat but lights are on circuit High Temperature Limit
Error message “E-10” Control section
• Drain valve open • Turn drain valve handle to
Error message “E-15” closed position
Foaming or boiling
• Water in shortening • At end of cook cycle, drain
over of shortening shortening and clean
• Improper or bad • Use recommended shortening
shortening
• Improper filtering • Refer to the procedure covering
filtering the shortening
• Improper rinsing after • Clean and rinse the frypot, then
cleaning the fryer dry thoroughly
Shortening will not
• Drain valve clogged • Open valve, force cleaning
drain from frypot with crumbs brush through drain
Filter switch ON but
• Motor thermal • Reset thermal switch per section
motor does not run protector tripped on Filter Pump Motor
Protector – Manual Reset
More detailed troubleshooting information is available at 1-800-417-8405 or 1-937-456-8405.
5-1 703