Henny Penny OEA/OGA-323 - Manual (Page 39)

Model OFE/OFG-321,322,323,324
3-11. FILTERING With Optional Filter Rinse Hose
OF SHORTENING a. Open the door and pull the collar back on the female
(Continued) quick-disconnect. Attach the male quick disconnect
on the filter rinse hose, onto the female fitting.
Figure 3-3.
b. Point the hose nozzle down into the frypot, close the
filter valve, and move the PUMP switch to the PUMP
position. Hold nozzle carefully to avoid excessive
splashing. Figure 3-4.
Use caution to prevent burns from splashing
hot shortening.
c. Rinse the frypot interior, especially hard to clean areas
like the frypot bottom and heating elements.
d. After sufficient rinsing, close the drain valve.
Figure 3-4 e. Turn the PUMP switch to the OFF position.
ONLY CONNECT AND DISCONNECT THE
FILTER RINSE HOSE WHEN THE PUMP
SWITCH IS IN THE OFF POSITION. FAILURE
TO DO THIS WILL RESULT IN SEVERE
BURNS FROM HOT SHORTENING SPRAYING
FROM THE FITTINGS. USE A DRY CLOTH OR
PROTECTIVE GLOVE TO AVOID BURNS.
f. Detach hose, and raise the fitting end of the hose high
FILTER HANDLE for a minute to allow remaining shortening in the hose
to drain back into the frypot.
Autolift Open fryers
a. Close the drain valve.
b. Turn filter handle to the on position. Figure 3-5.
c. Fill the frypot 1/3 full.
d. Turn filter handle to the OFF position.
Figure 3-5
Use care when reaching across a frypot of hot
shortening. Severe burns could result.
703 3-19