Henny Penny OEA/OGA-323 - Manual (Page 63)

Model OFE/OFG-321,322,323,324
4-3. SPECIAL PROGRAM Energy Save Enabled? (Gas fryers only) (SP-19)
MODE (Continued)
The Energy Save mode reduces energy used during idle
(non-cooking) periods by turning off the blower (draft fan)
and pilot flame when possible.
a. Follow steps 1 and 2 above.
b. Press PROG until "SP-19" and “ENERGY SAVE
ENABLED ? ” shows in display, along
with “YES/NO” option.
c. Press and release UP and DOWN buttons to change from
“NO” (default) to “YES”, or vise-versa.
Press and hold PROG at any time to exit Special Program
Mode.
Clean-Out Minutes (Sp-20)
This allows you to set the number of minutes of the Clean-
Out Mode.
a. Follow steps 1 and 2 above.
b. Press until “SP-10” and “CLEAN-OUT
MINUTES” shows in display, along with the preset
minutes.
c. Press to change the number of minutes, up to 99.
Clean-Out Temperature (Sp-21)
This allows you to set the temperature of the Clean-Out
Mode.
a. Follow steps 1 and 2 above.
b. Press until “SP-11” and “CLEAN-OUT
TMP” shows in display, along with the set temperature.
c. Press to change the temperature, up to
212ºF (100ºC).
4-4. DATA LOGGING, HEAT
The Data Logging, Heat Control, Tech, and Stat
CONTROL, TECH, AND modes are advanced diagnostic and program modes,
STAT MODES
mainly for Henny Penny use only. For more information
on these modes, contact the Service Department at
1-800-417- 8405 or 1-937-456-8405.
207 4-15