Henny Penny OEA/OGA-323 - Manual (Page 55)

Model OFE/OFG-321,322,323,324
4-3. SPECIAL PROGRAM
MODE (Continued)
When using solid shortening, it is recommended to
melt some of the shortening on an outside heating
source before placing the shortening in the frypots.
The heat exchange tubes must be completely
surrounded by liquid shortening. Fire or damage to
the frypot could result.
Idle Mode (SP-8)
An Idle Mode can be programmed to allow the shortening
temperature to drop to a lower temperature when not in
use. This will be a savings on the shortening and utilities.
a. Follow steps 1 and 2 above.
b. Press and release the PROG button 7 times.
“SP-8” and “IDLE MODE ENABLED?” flash in the
display, along with “NO” or “YES” on the right side of
the display.
c. Press and release the UP or DOWN buttons to toggle
from “NO” to “YES”, or vice versa.
d. With “YES” in the display, the Idle Mode is enabled.
Press and release the PROG button. “SP-8A” and
“IDLE SET PT TEMP” show in the display, along
with the preset temperature in the right side of the
display.
e. The setpoint, at which the temperature the shortening
will stay idle at, can be changed at this time by pressing
the UP or DOWN buttons.
f. Press and release the PROG button. “SP-8B” and
“AUTO-IDLE MINUTES” show in the display, along
with the preset time on the right side of the display.
g. Press the UP and DOWN buttons to set the minutes the
open fryer stays idle before the auto-idle is enabled, “60”
is the maximum, “OFF” the minimum. Ex.,“30” in the
display means, if product is not cooked in that particular
frypot for 30 minutes, the control automatically cools the
shortening down to the idle setpoint temperature,
programmed above.
h. To use product button number 6 (P6) as the idle button
(P12 for 12 button controllers), press the PROG button.
“SP8C” and “USE P6 FOR IDLE” (12 for 12 button
controllers), show in the display, along with “NO” or
“YES” on the right side of the display.
703 4-7