Henny Penny OEA/OGA-323 - Manual (Page 50)

Model OFE/OFG-321,322,323,324
4-2. PRODUCT PROGRAM
7. Press and release the PROG button a second time and
MODE (Continued) “TEMP” shows in the display, along with the preset
temperature on the right side of the display. Press the UP or
DOWN button to change the temperature. Press and hold
the buttons and the temperature will jump by 5 degree
increments to a maximum of 390 F (200ºC), and a minimum
of 200 F (100ºC).
8. Press and release the PROG button a third time and
“ COOK ID” shows in the display along with the product
ID. For example, FF would be the ID for french fries
And NU would be the ID for nuggets. Press the UP and
DOWN arrows to change the ID letters.
9. Press and release the PROG button a fourth time and
“LOAD COMP” shows in the display along with the
load compensation value on the right side of the
display. Press and release the UP and DOWN arrows to
change this value to a maximum of 20 and a minimum
of 0.
10. Press and release the PROG button a fifth time and
“LCOMP AVG” shows in the display along with the
load compensation average temperature on the right side
of the display. Press and release the UP and DOWN arrows
to change this value to a maximum of 50 degrees below
the setpoint temperature.
11. Press and release the PROG button a sixth time and
“ALARM – 1 AT 0:00” shows in the display. Press and
release the UP and DOWN arrows to set a time an alarm is
to sound. Ex., If a cook cycle was set at 3 minutes, and an
alarm was to go off after 30 seconds into the cook cycle,
2:30 would be set in the display at this time. When the
timer counts down to 2:30 the alarm will sound.
Up to 4 alarms can be programmed. After the first one is set,
the other alarms can be accessed by pressing the PROG
button again.
4-2 703