Henny Penny OEA - Manual

Model OFE/OFG/OEA/OGA-341, 342
3-1. OPERATING COMPONENTS Reference Figure 3-1.
C1000 CONTROLS
Fig.
Item Description Function
No. No.
3-1
1 Digital Display Shows the shortening temperature, the timer countdown in
the Cook Cycle, and the selections in the Program Mode; the
temperature of the shortening can be shown by pressing
once, or twice to view set-point temperature;
if shortening temperature exceeds 425
°F (218°C), the display
reads “E-5, FRYER TOO HOT”
3-1
2 This LED lights when the shortening temperature is within 5
°
of the setpoint temperature, signaling the operator that the
shortening temperature is now at the proper temperature for
dropping product into the frypot
3-1 3 The timer buttons are used to start and stop Cook Cycles
3-1
4 The idle buttons are used to start an Idle Mode which reduces
the temperature of the shortening during non-use periods;
press and hold to exit the Idle Mode
3-1
5 The program button is used to access the Program Modes;
also, once in the Program Mode, it is used to advance to the
next parameter
3-1
6 & 7 Used to adjust the value of the currently displayed setting
in the Program Mode and to change set-point temperature for
the left frypot, or basket
3-1 8 & 9 Used to adjust the value of the currently displayed setting
in the Program Mode and to change set-point temperature for
the right frypot, or basket
Proceed onto Section 3-3, Filling or Adding Shortening
408
3-1
SECTION 3. OPERATION