Alarm sound type, Scanner power time-out timer – Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner User Manual
Page 71
Granit XP User Guide
55
Alarm Sound Type
You may change the alarm type for the scanner or base by scanning the appropri-
ate barcode below and then scanning a digit (0-7) barcode from the
Save
.
Default = 0.
The sounds are as follows:
Scanner Power Time-Out Timer
When there is no activity within a specified time period, the scanner enters low
power mode. Scan the appropriate scanner power time-out barcode to change the
time-out duration (in seconds).
Note:
Scanning zero (0) is the equivalent of setting no time-out.
Setting
Sound
0
3 long beeps, medium pitch
1
3 long beeps, high pitch
2
4 short beeps, medium pitch
3
4 short beeps, high pitch
4
single chirps, medium pitch
5
2 chirps, then 1 chirp, medium pitch
6
single chirps, high pitch
7
2 chirps, then 1 chirp, high pitch
Base Alarm Type
Scanner Alarm Type