Direct part marking decoding, Data matrix message length, Data matrix code page – Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner User Manual
Page 206
190
Granit XP User Guide
Direct Part Marking Decoding
If you are having trouble reading Direct Part Marking (DPM) barcodes, scan
Dot-
peen DPM Decoding
for Dotpeen codes or scan
Reflective (Etched) DPM Decod-
ing
for reflective (etched) codes
.
Default = Disable DPM Decoding.
Data Matrix Message Length
Scan the barcodes below to change the message length. Refer to
(page 140) for additional information. Minimum and Maximum
lengths = 1-3116. Minimum Default = 1, Maximum Default = 3116.
Data Matrix Code Page
Data Matrix Code pages define the mapping of character codes to characters. If the
data received does not display with the proper characters, it may be because the
barcode being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the barcode below,
select the code page with which the barcodes were created (see
on page 284), and scan the value and the
Save
barcode
from the
beginning on page 289. The data characters should
then appear properly.
Dotpeen DPM Decoding
* Disable DPM Decoding
Reflective (Etched) DPM
Decoding
Minimum Message Length
Maximum Message Length
Data Matrix Code Page