Illumination lights, Aimer delay – Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner User Manual
Page 112

96
Granit XP User Guide
Illumination Lights
If you want the illumination lights on while reading a barcode, scan the
Lights On
barcode, below. However, if you want to turn just the lights off, scan the
Lights Off
barcode.
Default = Lights On.
Note:
This setting does not affect the aimer light. The aiming light can be set using
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the trigger is pulled
and when the picture is taken. During the delay time, the aiming light will appear,
but the LEDs won’t turn on until the delay time is over.
Default = Off.
* Lights On
Lights Off
1 millisecond
250 milliseconds
500 milliseconds
* Off
(no delay)