Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner - Manual (Page 102)

86 Granit XP User Guide
Presentation Mode
Presentation Mode uses ambient light and scanner illumination to detect bar-
codes. When in Presentation Mode, the LEDs remain dim until a barcode is pre-
sented to the scanner, then the aimer turns on and the LEDs turn up to read the
code. If the light level in the room is not high enough, Presentation Mode may not
work properly
Note: Cordless Granit XP scanners can only be used in presentation mode powered by the
battery; this mode cannot be used while docked.
Scan the following barcode to program your scanner for Presentation Mode.
Triggered Presentation Mode
This mode uses light to detect the presence of an object. Default = Ambient and
Scanner Light .
Presentation LED Behavior after Decode
When a scanner is in presentation mode, the LED aimer dims 30 seconds after a
barcode is decoded. If you wish to dim the LED aimer immediately after a barcode
is decoded, scan the
LEDs Off barcode, below. Default = LEDs On.
Presentation Mode
Ambient Light Only
*Ambient and Scanner Light
* LEDs On
LEDs Off