Show data format, Add a data format – Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner User Manual
Page 136
120
Granit XP User Guide
If you have changed data format settings, and wish to clear all formats and return
to the factory defaults, scan the
Default Data Format
code below.
Show Data Format
Scan the barcode below to show current data format settings.
Add a Data Format
Step 1.
Scan the
Enter Data Format
Step 2.
Select
Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. This allows you to save a total of 4 different data formats. To
program your primary format, scan
0
beginning on page 289. If you are programming an alternate format,
scan
1, 2
, or
3
, depending on which alternate format you are
programming. (See
Primary/Alternate Data Formats
further information.)
Step 3.
Terminal Type
(page 122) and locate the Terminal ID number
for your PC. Scan three numeric barcodes from the
beginning on page 289, to program the scanner for your terminal ID (you
must enter 3 digits). For example, scan
0 0 3
for an AT wedge.
Note: 099
indicates all terminal types.
Step 4.
Code I.D.
beginning on page 277, find the symbology to
which you want to apply the data format. Locate the Hex value for that
symbology and scan the 2 digit hex value from the
If you wish to create a data format for all symbologies, with the exception
of some specific symbologies, refer to B8 (
).
If you are creating a data format for Batch Mode Quantity, use
35
for the
Code I.D.
Note: 99
indicates all symbologies.
Step 5.
Length
Specify what length (up to 9999 characters) of data will be acceptable for
this symbology. Scan the four digit data length from the
* Default Data Format
Data Format Settings