Codabar start/stop characters, Codabar check character – Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner User Manual
Page 157

Granit XP User Guide
141
Codabar Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the barcode. You
may either transmit, or not transmit Start/Stop characters.
Default
=
Don’t Trans-
mit
.
Codabar Check Character
Codabar check characters are created using different “modulos.” You can program
the scanner to read only Codabar barcodes with Modulo 16 check characters.
Default
=
No Check Character.
No Check Character
indicates that the scanner reads and transmits barcode data
with or without a check character.
When Check Character is set to
Validate and Transmit
, the scanner will only read
Codabar barcodes printed with a check character, and will transmit this character
at the end of the scanned data.
When Check Character is set to
Validate, but Don’t Transmit
, the unit will only
read Codabar barcodes printed
with
a check character, but will not transmit the
check character with the scanned data.
Off
Transmit
* Don’t Transmit
* No Check Character
Validate Modulo 16, but
Don’t Transmit
Validate Modulo 16
and Transmit