Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner - Manual (Page 176)

160 Granit XP User Guide
UPC-A Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-A data.
Default = Off for both 2 Digit and 5 Digit Addenda.
UPC-A Addenda Required
When Required is scanned, the scanner will only read UPC-A barcodes that have
addenda. You must then turn on a 2 or 5 digit addenda listed on page 160 .
Default = Not Required.
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for
UPC-A Addenda Required . Set the length (in
milliseconds) for this timeout by scanning the barcode below, then setting the tim-
eout (from 0-120 milliseconds) by scanning digits from the
Programming Chart,
beginning on page 289 of this manual, then Save . Default = 500.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
2 Digit Addenda On
* 2 Digit Addenda Off
5 Digit Addenda On
* 5 Digit Addenda Off
Required
* Not Required
Addenda Timeout