Brother QL-810W Ultra-Fast Label Printer with Wireless Networking - Manual (Page 38)

Printing Using a Computer (P-touch Editor)
28
2
Connecting Using a Wired LAN (QL-820NWB only)
2
Note
To use a static IP address to connect your Label Printer to a wired LAN connection, install the printer
drivers and Printer Setting Tool, and then specify the wired LAN connection settings.
For more information, see
Installing the Software and Printer Drivers to a Computer on page 22.
a Unless wireless LAN is turned off, a wired LAN cannot be used. Turn off wireless LAN using the Printer
Setting Tool before connecting the Label Printer to a wired LAN connection.
b Turn off the Label Printer before connecting the LAN cable.
c Connect the LAN cable to the LAN Port on the back of the Label Printer.
d Connect the LAN cable to an active LAN Port on the network.
e
Turn the Label Printer On.
Note
The Label Printer's communication settings can be changed under [ Communication Settings ] in the
Printer Setting Tool. For more information on the Communication Settings, see General Tab on page 44.
Network Cable
2
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or 100BASE-TX Fast
Ethernet Network.
Note
Do not connect this product to any LAN connection that is subject to overvoltages.
Bluetooth Connection (QL-820NWB only)
2
Important
In order for the Label Printer and your Bluetooth-equipped computer or adapter to communicate, you must
first pair the Label Printer with the computer or mobile device using the Bluetooth management software
using your computer or mobile device.
a Press the Menu Button.
b Press the ▲ or ▼ Button to select the [ Bluetooth ] menu.
c Press the OK Button.
d Press the ▲ or ▼ Button to select [ Bluetooth(On/Off) ], then press OK Button. Press the ▲ or ▼
Button to select [ On ], then press OK Button.
e Use your Bluetooth management software to discover the Label Printer. Bluetooth communication is
now available.