Brother QL-810W Ultra-Fast Label Printer with Wireless Networking - Manual (Page 33)

Printing Using a Computer (P-touch Editor)
23
2
Connecting the Label Printer to a Computer
2
Refer to these directions for the type or connection method:
 USB cable connection
See
Connecting Using USB on page 23 .
 Wireless LAN connection
See
Connecting Using Wi-Fi on page 23.
 Bluetooth Connection (QL-820NWB only)
See
Bluetooth Connection (QL-820NWB only) on page 28.
 Wired LAN connection (QL-820NWB only)
See
Connecting Using a Wired LAN (QL-820NWB only) on page 28.
Connecting Using USB
2
a
Before connecting the USB Cable, make sure that the Label Printer is turned Off.
b
Connect the USB cable to the USB Port on the back of the Label Printer.
c Connect the USB cable to the USB Port on the computer.
d Turn the Label Printer On.
Connecting Using Wi-Fi
2
The following Wi-Fi connection methods are available:
 Wireless Direct
 Infrastructure Mode
 Infrastructure Mode + Wireless Direct
 WPS (Wi-Fi Protected Setup™)
Wireless Direct
2
Wireless Direct allows you to connect the Label Printer to your computer or mobile device directly without a
Wi-Fi access point/router; the printer serves as a Wi-Fi access point.
a Confirm the Wireless Direct settings of the Label Printer.
 Using the Label Printer (QL-820NWB only)
1 Press the Menu and
▼ Buttons to select the [ WLAN ] menu, and then press the OK Button.
Set [ WLAN (On/Off) ] to [ On ].
2 Press the Menu and ▼ Buttons to select the [ WLAN ] menu, and then press the OK Button.
3 Press the ▼ Button to select the [ Network Mode ] menu, and then press the OK Button.