Loading the dk roll – Brother QL-810W Ultra-Fast Label Printer with Wireless Networking User Manual
Page 15
Setting Up the Label Printer
5
1
Loading the DK Roll
1
a
Make sure that the Label Printer is turned Off.
Hold the Label Printer by the front, and firmly lift the DK Roll Compartment Cover to open it.
b
After removing the Protective Sheet, place the DK Roll into the Roll Spool Guide.
• Make sure that the Roll Spool Arm is inserted firmly in the Roll Spool Guide.
• Make sure the Stabilizer (1) slides into the notch of the Label Printer.
Note
If using P-touch Editor, select the DK Roll size in [
Paper Type
] (Windows) / [
Print Media
] (Mac) drop-down
list. For more information, see
DK Label & Tape Guide
which is included in the package or the
c
Thread the DK Roll through the Label Printer.
• Align the edge of the DK Roll with the upright edge of the Label Output Slot.
• Insert the first label into the slot inside the compartment.
• Push the label through the Label Output Slot until the end reaches the mark, as shown below.
1