Brother QL-810W Ultra-Fast Label Printer with Wireless Networking - Manual (Page 56)

Changing the Label Printer Settings
46
4
Wired LAN (QL-820NWB only) / Wireless LAN Tabs
4
The following explains about the Wired LAN (QL-820NWB only) and Wireless Tab in the settings dialog box.
TCP/IP (Wired/Wireless)
4
• Boot Method
Selects [ AUTO ], [ BOOTP ], [ DHCP ], [ RARP ], or [ STATIC ].
• IP Address/Subnet Mask/Gateway
Specifies the various networking values.
You can enter these settings only when the IP address is set to [
STATIC ].
• DNS Server Method
Selects [ AUTO ] or [ STATIC ].
• Primary DNS Server IP Address/Secondary DNS Server IP Address
You can enter these settings only when the DNS server is set to [ STATIC ].
IPv6
4
• Static IPv6 Address
Specifies a permanent IPv6 address.
• Enable this address
Enables the specified static IPv6 address.
• Primary DNS Server IPv6 Address/Secondary DNS Server IPv6 Address
Specifies the DNS server IPv6 addresses.
• IPv6 Address List
Displays the list of IPv6 addresses.
Wireless Settings
4
• Communication Mode
Selects [ Infrastructure ] or [ Ad-hoc ].
• SSID (Network Name)
Clicking [ Search ] displays the available SSID selections in a separate dialog box.
• Channel
Lists available channels.
Note
This setting is valid only in Ad-Hoc mode.
• Authentication Method/Encryption Mode
The supported encryption modes for the authentication methods are as shown in Communication Modes
and Authentication Methods/Encryption Modes on page 47.
• WEP Key
You can specify a setting only when WEP is selected as the encryption mode.
• Passphrase
You can specify a setting only when WPA/WPA2-PSK is selected as the authentication method.