Brother QL-810W Ultra-Fast Label Printer with Wireless Networking - Manual (Page 14)

Setting Up the Label Printer
4
1
Rear
1
1 AC Adapter Port
2 USB Port
3 USB Host
4 LAN Port
Important
Before using the Label Printer, make sure you remove the Protective Sheet, as shown below:
1 Make sure that the Label Printer is turned Off.
Hold the Label Printer by the front, and firmly lift the DK Roll Compartment Cover to open it.
2 Remove the Protective Sheet from the Label Output Slot.
• Do not throw away the Protective Sheet.
• When the Label Printer is not in use, lift the DK Roll Compartment Cover and remove any DK Rolls
from inside the Label Printer. Then, insert the Protective Sheet into the Label Output Slot to maintain
good printing quality.
QL-810W QL-820NWB
4
3
1
2
1
2
Protective
Sheet