Sony DT 11-18mm f/4.5-5.6 Lens - Manual (Page 76)

6. Menu Display and Settings: Shooting Menu 76
Shooting >S&Q Motion
Sets Slow & Quick Motion mode settings (page 49).
Item Sub-item setting Description
Setting On / Off Turns the Slow & Quick motion mode on/
off.
When set to On, the following functions
are disabled.
ˎ Auto iris
ˎ Auto focus
Frame Rate 1fps to 60fps / 100fps / 120fps / 150fps /
180fps / 200fps / 240fps Sets the frame rate for Slow & Quick
Motion shooting.
[Note]
The available settings vary depending on the
selected system frequency, codec, and video
format.
Shooting >LUT On/Off
Sets LUT settings.
Item Sub-item setting Description
SDI/HDMI MLUT On / MLUT Off Selects whether to apply monitor LUT to
the SDI and HDMI output video.
VF/Proxy/
Stream MLUT On / MLUT Off Selects whether to apply monitor LUT to
the viewfinder, proxy, and stream output
video.
Internal Rec MLUT On / MLUT Off Selects whether to apply monitor LUT to
the internal recording video.
Shooting >Noise Suppression
Sets noise suppression settings.
[Tip]
The Setting(Custom) and Level(Custom) settings are reflected in the Target Display setting (page 104).
Item Sub-item setting Description
Setting
(Custom) On / Off Turns the noise suppression function on/
off in Custom mode.
Level
(Custom) Low / Mid / High Sets the noise suppression level in
Custom mode.
Setting
(Cine EI) On / Off Turns the noise suppression function on/
off in Cine EI mode.
Shooting >Noise Suppression
Sets noise suppression settings.
[Tip]
The Setting(Custom) and Level(Custom) settings are reflected in the Target Display setting (page 104).
Item Sub-item setting Description
Level
(Cine EI) Low / Mid / High Sets the noise suppression level in Cine EI
mode.
Shooting >Flicker Reduce
Sets flicker correction settings.
Item Sub-item setting Description
Mode Auto / On / Off Sets the flicker correction mode.
Frequency 50Hz / 60Hz Sets the frequency of the power source
supplying the lighting that is causing the
flicker.
Shooting >SteadyShot
Sets image stabilization settings.
Item Sub-item setting Description
Setting Active / Standard / Off Sets the image stabilization function.
[Note]
Enabled when a compatible lens is attached.