Sony DT 11-18mm f/4.5-5.6 Lens - Manual (Page 19)

2. Preparation 19
Attaching Devices
Attaching a Microphone (sold
separately)
1
Place the microphone in the microphone
holder.
2
Connect the microphone cable to the
INPUT1 or INPUT2 connector.
INPUT
1
LINE MIC +48V MIC
2
LINE MIC +48V MIC
1
2
Microphone
Microphone
holder
INPUT1 INPUT2
3
Place the microphone cable into the cable
holder as shown in the diagram.
Cable holder
[Tips]
ˎ ˎ If you cannot attach the microphone securely, use the
spacer supplied with the microphone.
ˎ ˎ Depending on the type of lens attached, the tip of the
microphone may be visible in the camcorder image.
Adjust the position of the microphone.
Attaching the Viewfinder
[Note]
Attach/remove the viewfinder while the camcorder is
turned off.
Attaching the viewfinder to the front of
the handle
1
Insert the viewfinder mounting clamp
adaptor in the viewfinder attachment of
the handle (
 ), and turn the screw
(supplied) clockwise to secure it in
position (
 ).
The mounting clamp adaptor can be
freely attached in 45° increments, but the
position where the attachment point is
directly above the screw is recommended.
Screw
Viewfinder mounting
clamp adaptor
2
Mount the viewfinder clamp onto the
viewfinder mounting clamp adaptor (
 ),
and turn the locking knob clockwise to
secure it in position (
 ).
[Note]
Be sure to securely tighten the locking knob when using
a viewfinder. The viewfinder may fall off if the locking
knob is not tightened securely.
3
Align the  mark on the camcorder with
the  mark on the viewfinder connector,
and insert the cable.
Make sure that the
 mark is the outer
side before inserting the connector.
4
Place the cable into the cable holder as
shown in the diagram.
Cable holder