Sony DT 11-18mm f/4.5-5.6 Lens - Manual (Page 55)

3. Shooting 55
You can record the RAW video signal output
from the SDI OUT connector of the camcorder
to a supported external recorder.
1
Connect an external RAW recorder to the
SDI OUT connector of the camcorder.
2
Set the shooting mode using the Project
status screen (page 14) or Base Setting
>Shooting Mode (page 77) in the
Project menu of the full menu to Cine EI.
3
Set the scan mode (FF only) using Imager
Scan on the Project status screen or Rec
Format >Imager Scan Mode (page 77)
in the Project menu of the full menu.
4
Set the codec using the Project status
screen or Rec Format >Codec (page 77)
in the Project menu of the full menu to a
codec that includes RAW.
Selecting RAW & XAVC-I will
simultaneously record RAW video to the
external RAW recorder and video to the
memory cards in the camcorder.
5
Set the resolution using the Project status
screen or Rec Format >RAW Output
Format (page 77) in the Project menu
of the full menu.
6
Check that the external recorder is turned
on, then press the record START/STOP
button on the camcorder.
[Note]
When recording is started on an external recorder,
without using the record START/STOP button on
the camcorder, clips may not be recorded properly.
The supported RAW output formats are shown
below.
System
frequency Codec RAW Output
Format
59.94/
50/
29.97/
25/
23.98 RAW 4096Ч2160
3840Ч2160
RAW & XAVC-I 4096Ч2160
3840Ч2160
24 RAW 4096×2160
RAW & XAVC-I 4096×2160
Recording Status Indicator
When Display On/Off (page 87) >RAW
Output Control Status in the Monitoring
menu of the full menu is set to On, the RAW
recording status is indicated by an icon
displayed on the viewfinder screen.
[Note]
The recording control signal is output from the SDI
OUT connector of the camcorder, but it is not possible
to get the status of the external recorder. Accordingly,
the camcorder may indicate RAW video recording is
in progress when the external recorder is not actually
recording. Check the indicator on the external recorder
to obtain the correct operating status.
[Tip]
The RAW Output Format setting value is also displayed.
Slow & Quick Motion Recording
If S&Q Motion >Setting in the Shooting menu
is set to On, RAW video is recorded in Slow &
Quick Motion mode.
For details about the supported frame rates
for shooting, see page 49.
Recording RAW Video